Cisco 300-425

An engineer is designing a wireless network that will support many different types of wireless clients. When conducting the survey, which client must be used to ensure a consistent experience for all of the wireless clients?

An engineer added an AP to a deployment after a post-installation site survey. The engineer then notices an increase in co-channel interference and retransmissions. Which two features help mitigate the issue? (Choose two.

Two Cisco 5520 Wireless LAN Controllers are managing all APs throughout the network. The WLCs are in different locations to provide geographical redundancy. A mobility group has been configured on both WLCs and has an UP status on both controllers. The APs in location A are statically configured to use controller A as the primary and controller B as the secondary. If the WLC in location A goes offline, the APs successfully join the WLC in location B, but they do not fail over to the primary configured controller. Which configuration task fixes this issue?

A network engineer needs to create a wireless design to bridge wired IP surveillance cameras in the parking lot

through a mesh AP. To which operate mode of the AP should the cameras connect?

A wireless engineer is designing a wireless network to support real time applications over wireless. Which IEEE

protocol must the engineer enable on the WLC so that the number of packets that are exchanged between an

access point and client are reduced and fast roaming occurs?