Practice 300-615 Exam Online

Question 1

An engineer experiences an issue presented with the Cisco ucs system. Which action resolves the issue?

A : Change the discovery policy backplane speed preference to 4x10G.

B : Connect the adapter to the fabric interconnects using a breakout cable.

C : Update the 1/O module firmware on the Cisco UCS chassis.

D : Reboot the blade server and acknowledge the fault.

Answer: A

Question 2

Refer to the exhibit. A network engineer is troubleshooting a Cisco Nexus 5000 Series Switch. The interface between the server and the switch is nonoperational and is expected to operate at 10 Gbps. The drain rate of the interface is 3 Mbps. Which action resolves the issue?

A : Configure pause error-disable recovery

B : Enable link level pause on the interface

C : Reset priority flow counters

D : Set priority flow control pause

Answer: A

Question 3

'A network engineer troubleshoots an issue at a Cisco data center environment with these conditions:

* The data center has Cisco Nexus 9000 Series Switches running the vPC setup.

* The gateway of the servers is an HSRP IP address between the VLAN interfaces configured on both Cisco Nexus switches.

* Some of the client application servers are implementing fast-path forwarding for the return traffic.

* Those servers are sending the return traffic to the VLAN interface MAC address instead of the HSRP MAC address.

The network engineer discovers that some traffic is dropped because it passes the vPC peer link to be forwarded out the vPC interface. What must be configured on the vPC switches to resolve the issue?

A : peer-switch

B : peer-gateway

C : arp synchronize

D : spanning-tree

Answer: B

Question 4

A fabric interconnect fails to start, and the console displays the loader prompt. Which two actions resolve the issue? (Choose two.)

A : Load an uncorrupt bootloader image.

B : Load an uncorrupt kickstart image.

C : Reconnect Layer 1 and Layer 2 cables between the FIs.

D : Reformat the fabric interconnect

E : Load the correct version of the boot image.

Answer: A,B

Question 5

300-615-page127-image46

Refer to the exhibit. RBAC is configured on the MDS switch for a new SAN administrator engineer to work on

the FSPF configuration. However, after the configuration is applied the engineer who was assigned the

FSPF_Admin role cannot perform any configuration changes. Which action resolves the issue?

A :

Write rule 2 before rule 1

B : Remove rule 1 from the role

C : Configure the switch license for RBAC

D : Reload the switch

Answer: A

Name:	Troubleshooting Cisco Data Center Infrastructure
Exam Code:	300-615
Certification:	CCNP Data Center
Vendor:	Cisco
Total Questions:	221
Last Updated:	Apr 03, 2026

Cisco 300-615 Answers