Practice 300-620 Exam Online

Question 1

Which two actions extend a Layer 2 domain beyond the ACI fabric? (Choose two.)

A : extending the routed domain out of the ACI fabric

B : creating a single homed Layer 3 Out

C : creating an external physical network

D : extending the bridge domain out of the ACI fabric

E : extending the EPG out of the ACI fabric

Answer: D,E

Question 2

Which protocol is used in a Multi-Pod topology to synchronize reachability information across pods?

A : MP-BGP EVPN

B : OSPF

C : IS-IS

D : COOP

Answer: A

Question 3

Refer to the exhibit. An engineer connects a Cisco ACI fabric to two different Cisco Nexus 9000 Series Switches. The fabric must be configured to ensure a loop-free topology and N9K1 must be configured as the root bridge for VLAN 10. Which action meets these requirements?

A : Enable STP on ports between the leaf and spine.

B : Set BPDU Guard on ports between the leaf and Nexus 9000 Series Switches.

C : Enable Cisco Discovery Protocol on ports between the leaf and spine.

D : Activate MCP on ports between the leaf and Nexus 9000 Series Switches.

Answer: D

Question 4

Which endpoint learning operation is completed on the egress leaf switch when traffic is received from an L3Out?

A : The source MAC and IP address of the traffic is learned as a local endpoint.

B : The source MAC address of the traffic is learned as a remote endpoint.

C : No source MAC or IP address of the traffic is learned as a remote endpoint.

D : The source IP address of the traffic is learned as a remote endpoint.

Answer: C

Question 5

A situation causes a fault to be raised on the APIC. The ACI administrator does not want that fault to be raised because it is not directly relevant to the environment. Which action should the administrator take to prevent the fault from appearing?

A : Under System -> Faults, right-click on the fault and select Acknowledge Fault so that acknowledged faults will immediately disappear.

B : Create a stats threshold policy with both rising and falling thresholds defined so that the critical severity threshold matches the squelched threshold.

C : Under System -> Faults, right-click on the fault and select Ignore Fault to create a fault severity assignment policy that hides the fault.

D :

Create a new global health score policy that ignores specific faults as identified by their unique fault code.

Answer: C

Name:	Implementing Cisco Application Centric Infrastructure
Exam Code:	300-620
Certification:	CCNP Data Center
Vendor:	Cisco
Total Questions:	294
Last Updated:	Aug 11, 2026

Cisco 300-620 Answers