Cisco 300-710 Answers

An engineer is configuring Cisco FMC and wants to allow multiple physical interfaces to be part of the same VLAN. The managed devices must be able to perform Layer 2 switching between interfaces, including subinterfaces. What must be configured to meet these requirements?

When a Cisco FTD device is configured in transparent firewall mode, on which two interface types can an IP address be configured? (Choose two.)

An engineer must configure an inline set on a Cisco Secure IPS by using the Cisco Secure Firewall

Management Center. The inline set must make a copy of each packet before analyzing the packet and block

any connections that do not complete the three-way handshake. These configurations have been performed

already:

Select and enable the interfaces that will be added to the inline set.

Configure the speed and duplex.

Configure the inline set and add the interfaces to the inline set.

Which action completes the task?

Which interface type allows packets to be dropped? 

A network administrator is implementing an active/passive high availability Cisco FTD pair.

When adding the high availability pair, the administrator cannot select the secondary peer.

What is the cause?