Practice 350-501 Exam Online

Question 1

After troubleshooting multiple outages on the network due to repeated configuration errors, the network architect asked an engineer to enable NETCONF to facilitate future configurations. The configuration must enable syslog messaging to record NETCONF notifications from each of the numerous devices on the network. Which configuration must the engineer apply?

A :

username cisco test taker privilege 15 password 0 cisco test

aaa new-model

aaa authorization exec default local

snmp-server community cisco test RW

netconf-yang cisco-ia snmp-community-string ciscotest

logging history warnings

B :

username cisco test taker privilege 15 password 0 ciscotest

aaa new-model

aaa authorization exec default local

snmp-server community ciscotest RW

netconf-yang cisco

logging history critical

C :

netconf-yang

username ciscotesttaker privilege 15 password 0 ciscotest

aaa new-model

aaa authorization exec default local

snmp-server community ciscotest RW

netconf-yang cisco-ia snmp-community-string ciscotest

logging history debugging

D :

netconf-yang

username ciscotesttaker privilege 15 password 0 ciscotest

snmp-server community ciscotest RW

netconf-yang cisco-ia snmp-community-string ciscotest

logging history informational

Answer: C

Question 2

Refer to the exhibit.

An engineer implemented OSPF neighbor relationship on an IOS device. Which configuration must be applied to get the OR/BOR election removed from interfaces running OSPF?

A : ip ospf network broadcast on interfaces running OSPF

B : ip ospf network point-to-point on interfaces running OSPF

C : ip ospf network multipoint-point on interfaces running OSPF

D : ip ospf network non-broadcast on n:erfaces running OSPF

Answer: D

Question 3

Refer to the exhibit. A network engineer is configuring router RB to secure BGP advertisements against route hijacking activity. RB must validate all prefixes that it receives from origin AS 200 before installing them in the BGP route table. Which configuration meets the requirement?

A :

RB(config)# router bgp 100

RB(config-router)# address-family ipv4 unicast

RB(config-router-af)# bgp bestpath origin-as use validity

B : RB(config-bgp)# router bgp 100

RB(config-bgp)# bgp origin-as validation signal ibgp

RB(config-bgp)# bgp bestpath origin-as allow invalid

C :

RB(config-bgp)# router bgp 100

RB(config-bgp)# bgp origin-as validation time off

D :

RB(config)# router bgp 100

RB(config-router)# address-family ipv4 unicast

PB(config-router-af)# bgp origin-as validation enable

Answer: D

Question 4

A company needs to improve the use of the network resources that is used to deploy internet access service to customers on separate backbone and internet access network. Which two major design models should be used to configure MPLS L3VPNs and internet service in the same MPLS backbone? (Choose two.)

A : Carriage of full internet routes in a VPN, in the case of internet access VPNS

B : Internet routing through global routing on a PE router.

C : Internet access routing as another VPN in the ISP network.

D : Internet access through leaking of internet routed from the global table into the L3VPN VRF

E : Internet access for global routing via a separate interface in a VRF

Answer: B,D

Question 5

Exhibit:

A : Configure the device to choose the best MED from the same AS.

B : Set the device to ignore the conditional MED if the route originated in a different autonomous system.

C : Enable MED comparison between routes from neighbors in different AS.

D : Implement deterministic MED to choose the best route from the different AS.

Answer: C

Name:	Implementing and Operating Cisco Service Provider Network Core Technologies
Exam Code:	350-501
Certification:	CCNP Service Provider
Vendor:	Cisco
Total Questions:	560
Last Updated:	May 10, 2026

Cisco 350-501 Answers