Practice 5V0-22.21 Exam Online

Question 1

Which two considerations should an architect make when designing a HCI Mesh solution with VMware vSAN and VMware vSphere High Availability (HA)? (Choose two.)

A : If vSphere HA is to work with HCI Mesh, Datastore with All Paths Down (APD) must be configured to Power off and restart VMs.

B : If vSphere HA is to work with HCI Mesh, Datastore with Permanent Device Loss (PDL) must be configured to Power off and restart VMs.

C : A minimum of three nodes are required within the client cluster for vSphere HA to work.

D : A client cluster can mount up to ten remote datastores from one or more vSAN server clusters.

E : A server vSAN cluster can serve its local datastore up to five client vSAN clusters.

Answer: A,B

Question 2

A vSAN administrator was presented with 30 additional vSAN ReadyNodes to add to an existing vSAN cluster.

There is only one administrator to complete this task.

What is the fastest approach?

A : Use a Host Profile that was extracted from an existing host.

B : Clone the ESXi boot partition to all new hosts, since the hardware is identical.

C : Run vim-cmd to capture, and apply the configuration from an existing host.

D : Launch Quickstart to Add Hosts to a vSAN Cluster

Answer: A

Question 3

An administrator has discovered that space utilized by VMs does not decrease after deleting files and folders

within the VMs. The administrator needs to be able to reclaim this space.

Which action could the administrator take to accomplish this task?

A : Disable Storage I/O Control for the vSAN cluster.

B : Reboot the VM to recreate the swap file.

C :

Set the Object Space Reservation rule to 100%.

D :

Enable TRIM/UNMAP for the vSAN cluster.

Answer: D

Question 4

Which two characteristics are associated with vSAN Data-In-Transit Encryption? (Choose two.)

A : Uses AES-256 bit encryption

B : Requires an external KMS in order to work

C : Needs specific configuration on the Network switches in order to be enabled

D : Can be enabled independently of the vSAN Data-At-Rest encryption

E :

Needs to be enabled using vSAN Storage Policies

Answer: A,D

Question 5

A vSAN administrator has been tasked to add capacity to an existing vSAN cluster and has ordered enough larger capacity devices to complete this work. Tests have been executed, and the replacement from one single capacity device will require 70 minutes.

Which two approaches can the vSAN administrator use to complete this task? (Choose two.)

A : Confirm with pre-check that enough capacity for data migration is available, select a capacity device, click 'remove disk' with 'Ensure accessibility', replace capacity device, claim unused device, and then repeat one-by-one.

B : 'Change object repair timer to 75 minutes', 'set capacity device to offline', and then replace capacity device one-by-one.

C : Enter Maintenance Mode, confirm that pre check is fine, select 'Full data migration', 'Shutdown ESXi host', replace all capacity devices, 'Restart ESXi host', replace capacity devices in disk groups, exit Maintenance Mode, confirm that raw capacity has been increased, and then repeat on ESXi host one-by-one.

D : 'Shutdown ESXi host', and replace all capacity devices. Repeat this sequence one-by-one.

E : Execute a 'Data Migration Pre-Check', enter Maintenance Mode with default setting, 'Shutdown ESXi host', replace all capacity devices, and then repeat on ESXi hosts one-by-one.

Answer: C,D

Name:	VMware vSAN Specialist
Exam Code:	5V0-22.21
Certification:	VMware Specialist
Vendor:	VMware
Total Questions:	151
Last Updated:	Apr 25, 2024

VMware 5V0-22.21