Practice JN0-363 Exam Online

Question 1

You are deploying an MC-LAG connection at the edge of your network to a new customer. This solution must ensure that traffic uses all available links when forwarding traffic between the two networks.In this scenario, which two statements are correct? (Choose two.)

A : Transit traffic sent between the two PE devices will use the ICL interface.

B : You must use active/active mode when defining the MC-LAG bundle.

C : You must use active/standby mode when defining the MC-LAG bundle.

D : Transit traffic sent between the two PE devices will use the bundle’s member interfaces.

Answer: A,B

Question 2

Exhibit

Referring to the exhibit, what must be included in the Route1 configuration when establishing an EBGP

session with the ISP?

A :

A local address must be specified.

B :

A local AS must be specified.

C :

The BGP session type internal must be specified.

D :

The BGP session type external must be specified.

Answer: A

Question 3

Click the Exhibit button.

Referring to the exhibit, which two statements are correct? (Choose two.)

A : Traffic ingressing ge-1/0/0 that is tagged with VLAN 200 will be dropped.

B : Traffic ingressing ge-1/0/0 that is tagged with VLAN 100 will be dropped.

C : Traffic ingressing ge-1/0/0 that is tagged with VLAN 100 will egress ge-1/0/4 with an outer VLAN tag of 200.

D : Traffic ingressing ge-1/0/0 that is tagged with VLAN 200 will egress ge-1/0/4 with an outer VLAN tag of 200

Answer: A,C

Question 4

Which statement is true about the BGP active state?

A : The BGP active state is the initial state where all BGP traffic is refused.

B : The BGP active state is when BGP attempts to acquire a peer by initiating a TCP connection

C : The BGP active state is when BGP waits for the TCP connection to be established.

D : The BGP active state is when BGP exchanges update, notification, and keepalive messages with its peer.

Answer: B

Question 5

Exhibit

You are asked to configure OSPF between routers R1 and R2 using IPv6 addresses.

Which two tasks will accomplish your objective? (Choose two.)

A : Issue the sec protocols ospf area 0.0.0.0 interface ge-0/0/1.0 command.

B : Under the [edit routing-options] hierarchy, configure a 32-bit router ID.

C : issue the set protocols ospf3 area 0.0.0.0 interface ge-0/0/1.0 command.

D : Under the [edit routing-options] hierarchy, configure a 128-bit router ID.

Answer: A,D

Name:	Service Provider Routing and Switching Specialist (JNCIS-SP)
Exam Code:	JN0-363
Certification:	Service Provider Routing and Switching
Vendor:	Juniper
Total Questions:	100
Last Updated:	Apr 22, 2024

Juniper JN0-363