Practice NS0-516 Exam Online

Question 1

When a drive fails in a Dynamic Disk Pool (DDP) with no free capacity, what happens to the data?

A : It is rebuilt using the on-board backup database

B : It is rebuilt using preservation capacity within the DDP

C : It is evacuated to the preservation capacity within the DDP

D : It is evacuated to a hot spare drive that is assigned to the DDP

Answer: B

Question 2

A company implemented Automatic Load Balancing (ALB). When the controller workloads are monitored, it becomes obvious that there is an imbalance and that ALB is not working correctly.

In this scenario, what are two causes of the problem? (Choose two.)

A : The company implemented a load balancing min-min algorithm that does not support ALB

B : The company implemented an adaptive load balancing agent that does not support ALB

C : The company implemented a host multipath driver that does not support ALB

D : The company implemented a host type that does not support ALB

Answer: C,D

Question 3

An administrator is asked to provision a 1 TB volume to hold non-critical temporary data for a seismic-analysis application. The volume requires the highest possible IOPS.

In this scenario, which configuration would satisfy this requirement?

A : RAID 6 Dynamic Disk Pool with a 256 KiB segment size

B : RAID 5 volume group with a 256 KiB segment size

C : RAID 0 volume group with a 32 KiB segment size

D : RAID 6 Dynamic Disk Pool with a 32 KiB segment size

Answer: B

Question 4

An E2812 system, without expansion shelves, is configured with 12 Gb SAS host interface cards (HICs) and is directly connected to a host. However, the host cannot access the volumes.

In this scenario, which two troubleshooting steps should you take? (Choose two.)

A : Verify that the host can ping the E2812 system over the SAS link

B : Verify that the E2812 host port SAS link up lights are illuminated

C : Verify that the E2812 SAS CHAP secret is set

D : Verify that the correct SAS ports are in use on the E2812 system

Answer: B,D

Question 5

Which two steps are required to enable multifactor authentication on an E-Series system? (Choose two.)

A : Test SSO login

B : Configure In-Band Management

C : Map roles

D : Configure LDAP

Answer: A,D

Name:	NetApp Certified Implementation Engineer - SAN Specialist - E-Series
Exam Code:	NS0-516
Certification:	NCIE SAN Specialist
Vendor:	NetApp
Total Questions:	65
Last Updated:	May 29, 2026

NetApp NS0-516 Answers