Practice D-PEMX-DY-23 Exam Online

Question 1

An MX7000 administrator has been tasked to perform the initial configuration of a new MX platform. The

MX700 has seven MX740c, one MX5016s, two Management Modules (MMs), an LED-Only control panel,

two MX9116n in Fabric A, two MX5108n in Fabric B, and two MX5000s in Fabric C.

What is a valid method to perform the initial MX platform configuration?

A : Use a serial DB9 / DB cable

B : Use KVM and racadm setniccfg command from MM configuration menu

C : Use Ethernet front panel port default DHCP address

D : Use QuickSync 2

Answer: D

Question 2

An administrator is asked to install and power-on a new MX740c sled in an MX7000 chassis. The

administrator inserts the sled and presses the power button. They notice that the power button LED is

blinking green. After a short time power button turns to solid green and the server finally turns on.

What operation was in progress when the power button was blinking green?

A : iDRAC was booting

B : Lifecycle Controller update was in progress

C : Lifecycle Controller was taking firmware inventory

D : iDRAC was updating firmware

Answer: A

Question 3

What is a characteristic of MX7000 networking in Scalable Fabric Mode?

A : Enabled by default, all switch-specific OS10EE capabilities are available

B : Layer 2 bridging is disabled be default and interfaces must join a bridge domain (VLAN) before being to forward frames.

C : All switch interfaces are assigned to VLAN 1 by default and are in the same Layer 2 bridge domain.

D : Available on MX9116n FSE and MX7116n FEM but not on the MX5108n

Answer: D

Question 4

Which command(s) is supported in the current PowerEdge MX Redfish implementation?

A : PUT and DELETE

B : PUT only

C : HEAD and PUT

D : GET and DELETE

Answer: D

Name:	Dell PowerEdge MX Modular Deploy 2023
Exam Code:	D-PEMX-DY-23
Certification:	Dell EMC Implementation Engineer
Vendor:	Dell EMC
Total Questions:	55
Last Updated:	Apr 22, 2024

Dell EMC D-PEMX-DY-23